
10
WBP-200 SINGLE CHANNEL WIRELESS BELTPACK.
5. SPECIAL RECOMMENDATIONS
Don’t place the unit in close proximity to metallic surfaces and/or other electronic equipment in
order to avoid interferences.
In case of lose of range, reorient your body position to face up the base unit position.
Take special attention to the placement of the base station when trying to reach all the possible
placements of the beltpacks specially when concrete walls or other absorbing materials are in
between.
6. BATTERY CHARGER ALTAIR WBPC-200
The battery charger ALTAIR WBPC-200 allows to
charge up to four beltpacks ALTAIR WBP-200
simultaneously. The charge time is approximately of
three hours with the batteries totally discharged. After
this 2-3 hours time, the charger sets to trickle
(maintenance) mode and can be left alone in the
charger. For a full charge, it is recommended a 2 hours
minimum charging in this state.
CHANGING THE VOLTAGE AND THE FUSE
The battery charger ALTAIR WBPC-200 is set to operate at 230V, 50-60Hz and at 115V, 50-60Hz.
Make sure that the unit is disconnected of the mains.
In the unit rear panel, is placed the mains connector, the mains selector and the fuse holder.
The box bellow this mains connector is called fuse holder + mains selector. Take out the fuse holder
+ mains selector.
Upon extracting the fuse holder, the fuse will appear, take out it and change for the new one.
Insert the fuse holder into the mains connector again, without spin it (make sure that the voltage
to which it is going to connect the unit remains indicated in normal position, not inverted), if you only
wants to change the fuse. If what you want are change the mains voltage, rotate the fuseholder until
remains the mains voltage to which it is going to connect the unit in normal position, not inverted.
Battery charger ALTAIR WBPC-200 set up to 115 V.
Battery charger ALTAIR WBPC-200 set up to 230 V.
Komentáře k této Příručce